Sensors

iLight Sensors

These standard units allow the iLight system functions to be triggered automatically from a sensor.

iLight offer a comprehensive range of sensors designed to deliver energy efficiency, comfort and code compliance across a wide range of lighting applications. Programmable features make these units easy to set up, configure and use for a tailored solution for each individual requirement.

iCANnet Sensors

NS3-C

This multi sensor can be connected directly to the iLight iCANnet™ Network via CAN terminals. Featuring 3 functions: PIR motion detection, daylight measurement and an infra-red receiver.

Downloads

DALI Sensors

PPAD-C-DALI-ADDR

The PPAD-C-DALI-ADDR is a ceiling mounted, fully addressable DALI passive infrared PIR presence/absence detector designed to be part of the iLight DALI network

Downloads

MTS6 & MTS12

Combines daylight sensing and occupancy detection into a single device, communicates over DALI and allows for all device settings and groups to be adjusted remotely.

Downloads

PPAD-C-MB-DALI-ADDR

The PPAD-C-MB-DALI-ADDR is a compact, mid bay ceiling mounted, fully addressable DALI passive infrared PIR presence/absence detector designed to be part of the iLight Series DALI network.

Downloads

PPAD-C-MB-EXT-DALI-ADDR

The PPAD-C-MB-EXT-DALI-ADDR is a compact IP65 rated, mid bay ceiling mounted, fully addressable DALI passive infrared PIR presence/absence detector designed to be part of the iLight Series DALI network.

Downloads

PPAD-C-HB-DALI-ADDR

High sensitivity DALI PIR detector suitable for high bay applications, such as warehouses and factories, and where high detection sensitivity is needed.

Downloads

Low Voltage Sensors

AXCS01SRJ

This low voltage multi sensor combines PIR presence detection and a photocell in one compact flush mounting design using an RJ12 connector on the rear of the unit.

Downloads

MPAD-C-12-24V

The MPAD-C microwave presence/absence detector provides automatic control of lighting, heating and ventillation loads when connected to the iCAN network.

Downloads

MPAD-C-A-12-24V

A ceiling mounted, adjustable low voltage powered microwave presence/absence detector providing automatic control of lighting, heating and ventillation loads.

Downloads

MPD-C-EXT-12-24V

An IP66 rated ceiling mounted low voltage powered microwave presence detector, designed to provide automatic control of lighting, heating or ventilation loads.

Downloads

MPD-W-EXT-12-24V

An IP66 rated wall mounted low voltage powered microwave presence detector, designed to provide automatic control of lighting, heating or ventilation loads when connected to the iCAN network.

Downloads

PE2EXT

Low voltage exterior Photocell Detector, suitable for surface mounting. May be used for a daylight switching threshold or continuous level output for control of functions programmable within iCANsoft.

Downloads

ilight solo

For Mains Powered Stand Alone Sensors, view our iLight Solo Solution

Learn more